v2.0 (1.0.2.0) (EN)
3. General controls
5. Turning on the camcorder
microSD card slot
* To reset the camcorder (in case it is not functioning properly):
The camcorder has two operation modes (Preview and
Playback). It is always in Preview mode after switched on.
Refer to the diagram below for switching between modes.
English
Slide and hold the On/off switch for more than 10 seconds.
Recording indicator
QuickStartGuide
EZ2110 Series RCA Small Wonder Camcorder
Congratulations on purchasing your new RCA High Definition Small Wonder Camcorder.
Microphone
Lens
Switch on
Press PHOTO
On/off switch*
LCD screen
Please read these instructions for quick tips on using the product.
AV output
Preview mode 1
Take a photo
Video
quality
selector
Slide and
The User Manual PDF file can also be found in the camcorder memory under the User Manuals folder.
hold until the
camcorder turns
on or off
Auto timeout
USB and HDMI
video output
Press PHOTO /
Press Record
Playback/pause
Setup menu
1. Content of the box
Press PLAY/PAUSE
•
•
•
•
•
Small Wonder Camcorder
USB cable
AV cable
Tripod mount bracket
2 GB micro SD card (Installed in device)
•
•
•
•
•
Software DVD
User Manual
Quick Start Guide
Owner Registration card
Warranty leaflet
Delete recordings
Take photo
Playback mode
1 In Preview mode, press Record to record a video.
Record
Audio speaker
+/– – Adjust volume
during playback/
zoom during record
and preview
6. Selecting recording quality
Camcorder strap hole
Preview mode Selected recording quality
Battery indicator
/
– Skip to
2. Charging your camcorder
previous or next
recording; fast rewind
or forward
Please charge the battery for at least four hours before first use.
Memory card indicator
4. Inserting (or removing) memory card
A micro SD memory card (supplied) is recommended for recording.
USB port of your
computer
NOTE:
Lift up the cover
The unit is properly charging when you
see the animated charging symbol on the
Camcorder display.
To insert card: Push the card in until a click is heard
If you do not see this charging symbol, follow these
steps:
1. Make sure that you have the camcorder
connected to the computer USB port through
USB cable, and the computer is turned on.
2. Momentarily slide and hold the Camcorder power
switch to the ON position to initiate charging.
Settings Resolutions (pixel) &
Frame Rates (FPS)
Approx. recording durations
USB cable
on a 2 GB memory card2
Up to 1 hours
To remove card: Push card in until a click is heard, then slowly release
the card. As card is under minimal tension when locked in memory
slot, please use care when removing.
HD
1280 x 720 @ 30fps
720 x 480 @ 30fps
320 x 240 @ 30fps
HQ
Up to 1.7 hours
Up to 5 hours
WebQ
2 Actual recording time and capacity will vary depending on type of video content being recorded, system requirements,
and other factors.
As the memory card is small in size, it is recommended to use a small coin to help insert or remove it.
|