%0$0"'ZVGPUKQP"5RGCMGT
C
21-549
OWNER’S MANUAL — Please read before using this equipment.
Your CB Extension Speaker is designed for use with any CB Transceiver which has an
External Speaker jack, and for either mobile or base station application. It is acoustically
designed to cover the range of speech frequencies, and thus greatly enhances voice
intelligibility (even under high-noise mobile conditions).
Limited Ninety-Day Warranty
This product is warranted by RadioShack against
manufacturing defects in material and workmanship
under normal use for ninety (90) days from the date
of purchase from RadioShack company-owned
stores and authorized RadioShack franchisees and
dealers. EXCEPT AS PROVIDED HEREIN, Ra-
dioShack MAKES NO EXPRESS WARRANTIES
AND ANY IMPLIED WARRANTIES, INCLUDING
THOSE OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO THE DURATION OF THE WRITTEN
LIMITED WARRANTIES CONTAINED HEREIN. EX-
CEPT AS PROVIDED HEREIN, RadioShack SHALL
HAVE NO LIABILITY OR RESPONSIBILITY TO
CUSTOMER OR ANY OTHER PERSON OR EN-
TITY WITH RESPECT TO ANY LIABILITY, LOSS
OR DAMAGE CAUSED DIRECTLY OR INDI-
RECTLY BY USE OR PERFORMANCE OF THE
PRODUCT OR ARISING OUT OF ANY BREACH
OF THIS WARRANTY, INCLUDING, BUT NOT LIM-
ITED TO, ANY DAMAGES RESULTING FROM IN-
Speed Nuts
Bracket
Tapping Screws
Thumb Screw
CONVENIENCE,
LOSS
OF
TIME,
DATA,
PROPERTY, REVENUE, OR PROFIT OR ANY IN-
DIRECT, SPECIAL, INCIDENTAL, OR CONSE-
QUENTIAL DAMAGES, EVEN IF RadioShack HAS
BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES.
Some states do not allow limitations on how long an
implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the above
limitations or exclusions may not apply to you.
In the event of a product defect during the warranty
period, take the product and the RadioShack sales
receipt as proof of purchase date to any RadioShack
store. RadioShack will, at its option, unless other-
wise provided by law: (a) correct the defect by prod-
uct repair without charge for parts and labor; (b)
replace the product with one of the same or similar
design; or (c) refund the purchase price. All replaced
parts and products, and products on which a refund
is made, become the property of RadioShack. New
or reconditioned parts and products may be used in
the performance of warranty service. Repaired or re-
placed parts and products are warranted for the re-
mainder of the original warranty period. You will be
charged for repair or replacement of the product
made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure
caused by or attributable to acts of God, abuse, acci-
dent, misuse, improper or abnormal usage, failure to
follow instructions, improper installation or mainte-
nance, alteration, lightning or other incidence of ex-
cess voltage or current; (b) any repairs other than
those provided by a RadioShack Authorized Service
Facility; (c) consumables such as fuses or batteries;
(d) cosmetic damage; (e) transportation, shipping or
insurance costs; or (f) costs of product removal, in-
stallation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state.
Speaker
5. Insert the speaker's plug into the
+056#..#6+10
Transceiver's External Speaker (or
Remote Speaker) jack. Secure the wire
out of the way (use clamps or ties as
Carefully consider a convenient location
where your speaker will not get in the way,
and yet project sound to the best advantage.
You can mount it above or below a
dashboard, on a rear deck or any other
location. For mobile installations, keep in
mind the safety and convenience of vehicle
operation.
required).
RadioShack Customer Relations, 200 Taylor Street,
6th Floor, Fort Worth, TX 76102
1. Use the mounting bracket as a template
and mark holes for drilling.
12/99
3
16
2. Drill two / " (4.5 mm) holes. Take care
."%#76+10".
Avoid mounting in direct sunlight or high
that you don't drill into existing wiring or
trim.
•
•
•
temperature areas.
3. Mount the bracket with two tapping
screws and speed nuts.
Avoid running the wire across sharp metal
edges or moving parts.
Don't mount where it will block air
conditioning or heating vents.
4. Fasten the speaker between the bracket
using the two thumb screws. Swivel the
Speaker as desired and tighten the
thumb screws securely.
© 2002 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corp.
01A02
C
21-549
|