SR-110B
Cinema Surround Loudspeaker
Features
• Parallel outputs for feeding additional units
• 95˚ horizontal dispersion
• QuickMount bracket for fast, easy and secure installation
• High-power handling capability and rugged plywood enclosure
optimized for digital soundtrack reproduction
• THX™ approved for professional cinema applications
Developed specifically for the unique requirements of
professional motion picture playback, QSC extends its
commitmenttothecinemamarketwiththeintroduction
of the SR-110B Cinema Surround Loudspeaker. As a
member of QSC’s DCS Digital Cinema Speaker Series,
the SR-110B offers high-power handling, excellent
sensitivity, and extended bass response in a very
compact enclosure.
Specifications
Frequency Range1
-6 dB half space
50 Hz – 20 kHz
-10 dB half space
Nominal Coverage
Directivity Index
42 Hz – 20 Hz
90° horizontal x 85° vertical (averaged from 1 kHz to 10 kHz, -6 dB)
7.5 dB
5.6
Q
Maximum Output2
Calculated Peak at Rated Power
Calculated Continuous
Impedance
123 dB
117 dB
The SR-110B Cinema Surround Loudspeaker features
a high-power, long-throw 10" low-frequency transducer
coupled with a 1" titanium diaphragm compression
driver. The system’s plywood enclosure features a
15º down angle baffle and Array Optimized Tuning
(AOT) for optimum frequency response. The 200 watt
continuous power rating and sophisticated crossover
provides absolute reliability.
8Ω nominal
Maximum Input Power3
100 hours of 6 db crest factor
IEC 268 noise spectrum
150 W RMS
200 W RMS
2 hours of 6 db crest factor
pink noise, 50 Hz – 20 kHz,
AES method
Recommended Amplifier Power
Sensitivity 1 watt/1 meter, half space
Crossover Frequency
400 W RMS maximum into 8Ω
94 dB
2.6 kHz
The compact black enclosure with black grille blends
into any theatre decor. A new QuickMount bracket
design allows for fast, easy and secure installation. The
loudspeaker half of the bracket comes pre-installed
on each SR-110B. The QuickMount wall bracket
is purchased separately to allow shipment to the
job site ahead of the loudspeakers. A traditional
U-bracket is also available in lieu of the QuickMount
bracket system.
Recommended Processing
Connectors
Subsonic filter at 50 Hz as provided by QSC DCA amplifiers
Barrier strip screw terminals accept up to #10 AWG stranded wire
Transducers
10" long throw low-frequency transducer
1" titanium diaphragm compression driver on a CD horn
Enclosure
Plywood, baffle angle is 15° downward
23" x 12" x 12.25" (584 mm x 304 mm x 311 mm)
31 lb (14 kg)
Dimensions (HWD)
Weight – Net
1) All frequency ranges specified refer to measured free field response (half space, 2π).
2) Calculated SPL at 1m, (half space, 2π), speaker operating at rated RMS power with pink noise within specified frequency range.
3) Maximum input power tested in accordance with IEC 268-5 recommendations, 50 Hz – 20 kHz band limiting, 6 dB signal crest factor.
|